Individual Alignments - Keysight A Series User Manual

SA (Spectrum Analyzer) Mode (Option 233–Mixed Analyzers)
SA Mode Settings

Individual Alignments

IMPORTANT! It is recommended that you use
All Now
Align
Align All Now includes the individual alignment InstAlign
Now,
have manual control over the individual alignments, then refer to the SA
Individual Alignment Control setting in
Chapter 30
The Individual Alignment softkey is only available, when the preference SA
- Individual Alignment Control is set to On in the FieldFox Preferences
menu. Refer to
How to Access Individual Alignments
This section assumes access to individual alignments was activated using the
FieldFox's system settings' Preferences. Once enabled, an Individual
Alignments softkey is displayed. Refer to
Chapter 30
1. Press Cal 5
2. Then
3. Then
4. Press Enter
How to make Amplitude Alignment settings
During continuous sweep (
Alignments will NOT interrupt the ongoing measurement, but when
necessary, will occur opportunistically as settings are changed. When no
automatic alignment updates occur, existing alignments can become stale
over time and temperature drift, so a warning annotation on the left panel
will light up indicating that alignments need updating.
SA, IQA, RTSA, and other modes use a proprietary amplitude alignment
algorithm to make extremely accurate amplitude measurements over the full
frequency range of the FieldFox.
These settings do NOT survive a Preset or Mode Preset.
Keysight N9927-90020 User's Guide
in lieu of the individual alignments
Now, and ChanEQ Align
Burst Align Now, and
System Settings.
"Preferences" on page
System Settings.
Individual Align
Amptd Align Now
Then Burst Align Now
Then ChanEq Align Now
All Alignment [Auto]
(Amptd Align
Now), because All Alignment [Auto] and
ChanEQ Align Now. But, if you would prefer to
"Preferences" on page
744, in Chapter 30
"Preferences" on page
or
or
acquisition for IQA) operation, automatic
" "
or Align
Now, Burst
Amptd Align
744, in
System Settings.
744, in
219