Editing Antenna Correction Factors And Adding New Antenna Factors - Keysight A Series User Manual

SA (Spectrum Analyzer) Mode (Option 233–Mixed Analyzers)
How to Set Up EMF Settings (Requires EMF (Option 358), GPS (Option 307), and SA
Mode (Option 233–Mixed Analyzers))

Editing Antenna Correction Factors and Adding New Antenna Factors

This section contains two procedures illustrating how to edit the Antenna
Factors settings table values.
If New is selected under the X, Y, or Z Antenna or Cable softkey menu,
whatever antenna or cable factors that have been imported as the default
values and are displayed in the Settings table.
1. Selecting an antenna softkey menu:
2. For this example, the X axis Antenna softkey menu has been selected:
246
For more details on editing the USB antenna, refer to
Antennas – (Full Capability Requires EMF Option 358, and SA mode
(Option 233 Mixed Analyzers))."
Press Scale/Amptd > More
menus:
— X axis Antenna
triaxial antenna.
— Y axis Antenna
triaxial antenna.
— Z axis Antenna
triaxial antenna.
— Cable – to open a softkey menu to edit the cable factors for an
antenna setup.
a. Then press Edit Antenna
Frequency and Antenna Factor table values that are stored in the
FieldFox [:Internal]:\Antenna\ directory (Refer to
9-21). Then you can edit the following:
— Description – edits the name of the current antenna settings
table
— Antenna Factor Unit – edits the units from dB /m electric
antenna factor (default) to dB S/m for the magnetic antenna
factors. None is displayed, when no antenna is detected.
— Frequency – edits the frequency value measured that
corresponds to a particular Antenna Factor.
— Antenna Factor – edits the Antenna Factor that corresponds
to a particular frequency.
Refer to next step for details on editing the antenna Settings
table.
> Corrections then choose one of these softkey
– to open a softkey menu to edit the X axis of a
– to open a softkey menu to edit the Y axis of a
– to open a softkey menu to edit the Z axis of a
to edit the existing X axial antenna factor's
Keysight N9927-90020 User's Guide
Chapter 15, "USB
Figure