Cat (Cable And Antenna Test) Mode - Option 305 - Keysight N9923A FieldFox User Manual

CAT (Cable and Antenna Test) Mode - Option 305

CAT Mode is typically used to test an entire transmission system, from the
transmitter to the antenna. This process is sometimes referred to as Line Sweeping.
CAT Mode is similar to NA (Network Analyzer) Mode. Learn more at the FieldFox
Supplemental Online Help:
http://na.support.keysight.com/fieldfox/help/FieldFox.htm
CAT Mode Distance to Fault measurements are discussed on page 54.
In this Chapter
Measurement Selection ........................................ 45
Quick Settings ....................................................... 46
Frequency Range .................................................. 46
Scale Settings ....................................................... 47
Averaging ............................................................. 47
Single/Continuous ................................................ 48
Resolution ............................................................. 48
Sweep Time........................................................... 49
Output Power ........................................................ 49
Interference Rejection .......................................... 49
Coupled Frequency ............................................... 50
Procedures
Return Loss Measurement.................................... 51
1-Port Cable Loss Measurement .......................... 51
2-Port Insertion Loss Measurement ..................... 52
Distance to Fault Measurements ......................... 54
See Also
All about Calibration ............................................. 62
Set Markers ......................................................... 110
Use Limit Lines .................................................... 118
Use Trace Math ................................................... 122
44 FieldFox User's Guide