Saving Data With Gps Enabled; More Gnss Settings - Keysight A Series User Manual

System Settings
System Configuration
—

Saving Data with GPS Enabled

GPS position and clock data are included when data is saved with the following
files types: *.csv, *.SnP, State, State+Trace data save.
A warning is shown if the GPS is ON but unlocked at time of save, or if the GPS
feature is ON but no GPS is physically present at time of save.
The following is a sample S1P file with GPS information:
!GPS Latitude: 38 28.87717 N
!GPS Longitude: 122 42.66625 W
!GPS TimeStamp: 06/25/2010 16:24:48
!GPS Seconds Since Last Read: 2s
Saving GPS Display Data
To save the current GPS data displayed:
1. Press Save/Recall 9
2. Then
A menu opens to enable naming the file you are saving (*.png).

More GNSS Settings

These GNSS settings require that the A-Series FieldFox has been upgraded
with a new system board N9927-63074. Verify your system board by
pressing
System >
then verify in the Setting column the SB Part Number is N9927-63074.
FieldFoxes with serial number prefixes >MY60511001 / US60510101 /
SG60517001 /SG60518501 already have this new system board installed.
1. Press System 7 >
2. Then choose from the following:
762
Antenna Voltage Choose from:
— 3.3V 5V – Settable to: 3.5 VDC or 5 VDC. When the bias voltage is
set to ON and when the GPS is set to Internal. This system was
designed for an active antenna such as the Keysight N9910X-825
Save File Picture (PNG)
Service Diagnostics
System Configuration
— GPS Refer to "How to make GPS settings" on page
System Information
>
GNSS Selection
>
Keysight N9927-90020 User's Guide
759.