Keysight A Series User Manual page 374

Over–the–Air Measurements (OTA) – LTE FDD Option 370, LTE TDD Option 371, 5GTF
Option 377 (CPU2 Only)
How to Set Up Over–the–Air (OTA) Mode Settings
4. Select Trace 6—choose:
374
— Set the System > System Configuration
Source [GPS] >Back
— Set the GNSS (GPS+)
See also "GNSS (GPS+) and GPS" on page
— Set the Scale/Amptd to:
— RF Atten
— Preamp >
— Set the Freq/Dist >
All Measurement Setups:
— Press CC CCO
— Press Enabled OFF ON
component carriers. If only one CC is enabled, the OFF key
press is ignored (default = ON).
— Press Center
carrier center frequency.
For LTE FDD and LTE TDD (instrument dependent)
— Optional (LTE FDD and LTE TDD only):
——Freq Mode
——Then
— For 5GTF
— Window 1 2 3 4
— Then Win State OFF ON
— Then Data
— Table or
— Bar Chart
— Spectrum
>
> GNSS Receiver >
> 0 dB
ON
Center to:
Enable/disable selected
to select the currently displayed component
> Chan
Channel Table – Opens a menu to choose
your CC, Band, Channel, and then use
List, to open a softkey menu to save your
n.
(instrument dependent)
to ON
or
or
Keysight N9927-90020 User's Guide
Frequency Ref > Freq Ref
Internal > Esc
758.
Favorites
Setup