Siemens SINUMERIK 840D sl Series Diagnostics Manual page 464

Overview of Alarms
%2 = Block number, label
%4 = Program name
Definitions: Before a ShopTurn program can be executed, it has to be tested by ShopTurn.
Alarm triggered by following cycle: F_HEAD
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Simulate the subroutine first in ShopTurn or load it into the ShopTurn operating mode
"Machine auto".
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61236
Channel %1 block %2: ShopTurn subroutine %4 cannot be executed as not tested
by ShopTurn.
Parameters: %1 = Channel number
%2 = Block number, label
%4 = Subroutine name
Definitions: Before a ShopTurn subroutine can be used, it has to be tested by ShopTurn.
Alarm triggered by following cycle: F_HEAD.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Simulate the subroutine first in ShopTurn or load it into the ShopTurn operating mode
"Machine auto".
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61237
Channel %1 Block %2: Retraction direction unknown. Withdraw tool manually!
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The tool is in the retraction area and it is unknown in which direction it can be travelled out
of it.
Alarm triggered by following cycle: F_SP_RP
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Manually retract the tool from the retraction area defined in the program header and
restart the program.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61238
Channel %1 Block %2: Machining direction unknown!
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The direction of the next machining is unknown.
Alarm triggered by following cycle: F_SP_RP.
Reactions: - Interpreter stop
- NC Start disable in this channel.
2-464
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005