Siemens SINUMERIK 840D sl Series Diagnostics Manual page 205

08/2005
Remedy: Modify program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14160
Channel %1 block %2 tool length selection without geometry axis specification
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: If variant C (tool length acts on the programmed axis) is activated by machine data
$MC_TOOL_CORR_MODE for tool length compensation with H word and G43/G44 in
ISO_2 mode, at least one geometry axis must be specified.
Reactions: - Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Remedy: Change machine data $MC_TOOL_CORR_MODE or the part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14165
Channel %1 block %2 selected H number %3 does not match tool %4
Parameters: %1 = Channel number
%2 = Block number, label
%3 = H/D number of ISO mode
%4 = Tool number
Definitions: When an H or D number is programmed in ISO_2 mode, it must be available in the active
tool. The active tool may also be the last loaded tool on the master spindle or master tool-
holder. If there is no H or D number on this tool, this alarm will be output.
Reactions: - Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Remedy: Set H number correctly.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14170
Channel %1 block %2 illegal interpolation type with tool length compensation
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: If tool compensation (G43/G44) is activated in language mode ISO_2, the linear type of
interpolation must be active.
Reactions: - Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14180
Channel %1 block %2 H number %3 is not defined
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-205