Siemens SINUMERIK 840D sl Series Diagnostics Manual page 224

Overview of Alarms
14610
Channel %1 block %2 compensation block not possible
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: An alarm was output which could be eliminated basically via program correction. Since
the error occurred in a program which is processed from external, a compensation
block/program correction is not possible.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: • Abort program with reset.
• Correct program on MMC or PC.
• Restart reloading (possibly with block search and interrupt location).
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
14650
Channel %1 block %2 SETINT instruction with invalid ASUP input
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Asynchronous subroutines are subroutines that are executed following a hardware input
(interrupt routine started by a rapid NCK input).
The NCK input number must lie between 1 and 8. It is assigned a priority from 0 to 128 (1
is the highest priority) in the SETINT instruction with the keyword PRIO = ... .
Example:
If NCK input 5 changes to "1" the subroutine LIFT_Z should be started with the highest
priority.
N100 SETINT (5) PRIO = 1 LIFT_Z
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Program the NCK input of the SETINT statement with a value of not less than 1 or greater
than 8.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14660
Channel %1 block %2 SETINT instruction with invalid priority
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The NCK input number must lie between 1 and 8. It is assigned a priority from 0 to 128 (1
is the highest priority) in the SETINT instruction with the keyword PRIO = ... .
Example:
If NCK input 5 changes to "1" the subroutine LIFT_Z should be started with the highest
priority.
N100 SETINT (5) PRIO = 1 LIFT_Z
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Program the priority of the NCK input with a value of not less than 1 or greater than 128.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
2-224
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005