Siemens SINUMERIK 840D sl Series Diagnostics Manual page 462

Overview of Alarms
61225
Channel %1 block %2: Swivel data record unknown
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: An attempt was made to access a swivel data block which has not been defined.
Alarm triggered by following cycles: E_TCARR, F_TCARR.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Select another swivel data block or define a new swivel data block.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61226
Channel %1 block %2: Inclinable head cannot be exchanged
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The parameter "Swivel data block" is set to "No". In spite of this, an attempt has been
made to change the swivel head.
Alarm triggered by following functions: E_TCARR, F_TCARR.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Set the parameter "Swivel data block" in the start-up screen form "Rotary axes" to "Auto-
matic" or "Manual".
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61230
Channel %1 Block %2: Tool probe diameter too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The tool probe has not been calibrated correctly.
Alarm triggered by following cycles: E_MT_CAL, E_MT_RAD, E_MT_LEN.
Remedy: Correct variable E_MESS_MT_DR[n] or E_MESS_MT_DL[n] for tool probe n+1 in data
block GUD7
(measuring in JOG).
61231
Channel %1 block %2: ShopMill program %4 not executable, as not tested by Shop-
Mill
Parameters: %1 = Channel number
%2 = Block number, label
%4 = Program name
Definitions: Before a ShopMill program can be executed, it has to be tested by ShopMill. Alarm trig-
gered by following cycle: E_HEAD.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: The program has to be simulated first in ShopMill or loaded into the operating mode
"Machine auto" by ShopMill.
2-462
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005