Siemens SINUMERIK 840D sl Series Diagnostics Manual page 176

Overview of Alarms
12730
Channel %1 block %2 no valid transformation machine data parameterized
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The machine data $MC__TRAFO_TYPE_1, $MC_TRAFO_AXES_IN_1[1],
$MC_TRAFO_AXES_IN_2[1] are incorrectly set for G07.1, G12.1.
Reactions: - Correction block
- Interface signals are set.
- Alarm display.
Remedy: Enter valid transformation identifier for TRACYL in $MC__TRAFO_TYPE_1 and the
rotary axis number in $MC_TRAFO_AXES_IN_1[1] or $MC_TRAFO_AXES_IN_2[1].
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
12740
Channel %1 block %2 modal macro call %3 not possible
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Source string
Definitions: When calling a modal macro no other modal macro, modal cycle or modal subroutine may
be active.
Reactions: - Correction block
- Interface signals are set.
- Alarm display.
Remedy: Modify part program
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
14000
Channel %1 block %2 illegal end of file
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Part program was not terminated with M30, M02 or M17. This error is also signalled at the
host if the environment variables NCPROG or NCUPROG have been set to a non-exist-
ing file.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: End part program with M30, M02 or M17 and start part program. Check environment vari-
ables NCPROG and NCUPROG at the host.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
14001
Channel %1 block %2 illegal end of block
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: After system-internal data manipulation (e.g. when transferring blocks from an external
source) a subfile can end without having LF as the last character.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
2-176
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005