Siemens SINUMERIK 840D sl Series Diagnostics Manual page 386

Overview of Alarms
- Alarm display.
- NC Stop on alarm.
Remedy: Repeat entry with correct value and then Power On.
Program Con- Switch control OFF - ON.
tinuation:
26016
Axis %1 machine data %2 invalid value
Parameters: %1 = Axis name, spindle number
%2 = String: MD identifier
Definitions: Machine data includes a value that is not valid.
Reactions: - NC not ready.
- The NC switches to follow-up mode.
- Mode group not ready, also effective for single axes
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Repeat entry with correct value and then Reset.
Program Con- Clear alarm with the RESET key in all channels of this mode group. Restart part program.
tinuation:
26017
Axis %1 machine data %2[%3] invalid value
Parameters: %1 = Axis name, spindle number
%2 = String: MD identifier
%3 = Index: MD array
Definitions: Machine data includes a value that is not valid.
Reactions: - NC not ready.
- The NC switches to follow-up mode.
- Mode group not ready, also effective for single axes
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Repeat entry with correct value and then Reset.
Program Con- Clear alarm with the RESET key in all channels of this mode group. Restart part program.
tinuation:
26018
Axis %1 setpoint output drive %2 used more than once
Parameters: %1 = Axis name, spindle number
%2 = Drive number
Definitions: A setpoint has been selected more than once. The machine data 30110
$MA_CTRLOUT_MODULE_NR contains the same value for different axes.
Reactions: - Mode group not ready.
- The NC switches to follow-up mode.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
2-386
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005