Siemens SINUMERIK 840D sl Series Diagnostics Manual page 64

Hide thumbs Also See for SINUMERIK 840D sl Series:
Table of Contents

Advertisement

Overview of Alarms
If the alarm is displayed on start-up of compile cycles, this may be remedied by increasing
$MN_MM_CC_MD_MEM_SIZE.
Program Con-
Switch control OFF - ON.
tinuation:
6401
Channel %1 tool change not possible: Empty location for tool %2 Duplo no. %3 on
magazine %4 not available.
Parameters:
%1 = Channel ID
%2 = String (identifier)
%3 = Duplonummer
%4 = Magazine number
Definitions:
The tool cannot be moved into the selected tool magazine. There is no appropriate loca-
tion for this tool. A suitable location is mainly determined by the status. The status must
indicate that this location is free, not disabled, not reserved and not co-occupied by a tool
that is too large. Furthermore, it is important that the type of tool matches the type of any
magazine location that may be free. (If, for example, all magazine locations are of the 'B'
type and these are all free and the tool is of type 'A', then this tool cannot be put into this
magazine).
Reactions:
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy:
• Check whether the magazine data have been defined correctly.
• Check whether there is still room in the magazine to add another tool; there may not be
due to operating procedures.
• Check whether a location type hierarchy is defined and whether it, for example, does not
allow insertion of a type 'A' tool in a free location with type 'B'.
Program Con-
Clear alarm with the RESET key. Restart part program
tinuation:
6402
Channel %1 tool change not possible. Magazine no. %2 not available
Parameters:
%1 = Channel ID
%2 = Magazine number
Definitions:
The desired tool change is not possible. The magazine with the specified number is not
available.
Reactions:
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy:
• Check whether the magazine data have been defined correctly.
• Check whether the magazine is connected to the desired tool holder/spindle via a dis-
tance relation.
• The user PLC program may have sent wrong data to the NCK.
Program Con-
Clear alarm with the RESET key. Restart part program
tinuation:
6403
Channel %1 tool change not possible. Magazine location number %2 on magazine
%3 not available.
Parameters:
%1 = Channel ID
%2 = Magazine number
%3 = Magazine location number
2-64
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005

Advertisement

Table of Contents
loading

Table of Contents