Siemens SINUMERIK 840D sl Series Diagnostics Manual page 455

08/2005
Definitions: The alarm is triggerd by the following cycles: CYCLE832.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: --
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61193
Channel %1 block %2: compressor option not set up
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The alarm is triggerd by the following cycles: CYCLE832.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: --
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61194
Channel %1 block %2: spline interpolation option not set up
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The alarm is triggerd by the following cycles: CYCLE832.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: --
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61196
Channel %1 block %2: no swiveling in JOG --> 5 axis transformation and TCARR
simultaneously activated
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Five-axis transformation and TOOLCARRIER activated at the same time.
Alarm triggered by following cycles: CYCLE800.
Remedy: Five-axis transformation and TOOLCARRIER activated at the same time.
61197
Channel %1 block %2: no swiveling in JOG --> active WO G%4 and basic frames
contain rotations
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE800.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-455