Siemens SINUMERIK 840D sl Series Diagnostics Manual page 461

08/2005
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: No tool active.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Select a suitable tool.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61222
Channel %1 Block %2: Plane infeed greater than tool diameter
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The plane infeed must not be greater than the tool diameter.
Alarm triggered by following cycles: CYCLE79, , E_MI_PL, E_PO_CIR, E_PO_REC,
F_PO_CIR, F_PO_REC.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Reduce plane infeed.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61223
Channel %1 Block %2: Approach path too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The approach path must not be less than zero.
Alarm triggered by following cycles: E_MI_CON, F_MI_CON.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Enter a greater value for the approach path.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61224
Channel %1 Block %2: Retract path too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The retract path must not be less than zero.
Alarm triggered by following cycles: E_MI_CON, F_MI_CON.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Enter a greater value for the retract path.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-461