Siemens SINUMERIK 840D sl Series Diagnostics Manual page 443

08/2005
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Incorrect parameterization of NUM or INDA. The layout of the circle elements within a full
circle is not possible. Alarm triggered by following cycles: HOLES2, LONGHOLE, SLOT1,
SLOT2.
Reactions: - Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Remedy: Correct parameterization.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61107
Channel %1 block %2: First drilling depth incorrectly defined
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: First drilling depth is in the opposite direction to the total drilling depth. Alarm triggered by
following cycle: CYCLE83.
Reactions: - Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Remedy: Modify drilling depth.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61108
Channel %1 Block %2: Values for parameters _RAD1 and _DP1 not permissible
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The parameters _RAD1 and _DP for defining the path for the depth infeed have been
incorrectly specified. Alarm triggered by following cycles: POCKET3, POCKET4.
Reactions: - Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Remedy: Modify parameter.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61109
Channel %1 Block %2: Parameter _CDIR incorrectly defined
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The value of the parameter for the cutting direction _CDIR has been incorrectly defined.
Alarm triggered by following cycles: POCKET3, POCKET4.
Remedy: Change parameter _CDIR.
61110
Channel %1 Block %2: Finishing allowance at bottom > depth infeed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The finishing allowance at the base has been specified greater than the maximum depth
infeed. Alarm triggered by following cycles: POCKET3, POCKET4.
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-443