Siemens SINUMERIK 840D sl Series Diagnostics Manual page 261

08/2005
- Interface signals are set.
- Alarm display.
Remedy: Do not program spline and polynomial interpolation, or retrofit the necessary option.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
16300
Channel %1 block %2 denominator polynominal with zero places within parameter
range not allowed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The programmed denominator polynomial (with PL [ ] = ... , i.e. without specification of
geometry axis) has a zero place within the defined parameter range (PL = ...). This means
that the quotient of the numerator polynomial and the denominator polynomial is infinite or
indeterminate.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Modify the polynomial block so that there is no zero place within the polynomial length in
the denominator polynomial.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
16400
Channel %1 block %2 positioning axis %3 cannot participate in spline
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Definitions: An axis assigned to a spline grouping (n) with SPLINEPATH (n, AX1, AX2, ...) has been
programmed as positioning axis with POS or POSA.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Do not assign the positioning axis to the spline grouping.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
16410
Channel %1 block %2 axis %3 is not a geometry axis
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Definitions: A geometry axis has been programmed that cannot be imaged on any machine axis in the
current transformation (possibly there is no transformation active at the moment).
Example:
Without transformation: Polar coordinate system with X, Z, and C axis
With transformation: Cartesian coordinate system with X, Y, and Z, e.g. with TRANSMIT.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Activate transformation type with TRAORI (n) or do not program geometry axes that do
not participate in the transformation grouping.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-261