Siemens SINUMERIK 840D sl Series Diagnostics Manual page 463

08/2005
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61232
Channel %1 block %2: Impossible to load magazine tool
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Only manual tools may be loaded into a swivel head in which the tools can only be manu-
ally loaded.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Load a manual tool into the swivel head or set the parameter "Tool change" in the start-up
screen form "Rotary axes" to "Automatic".
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61233
Channel %1 block %2: Thread angle wrongly defined
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The thread angles were specified too large or too small.
Alarm triggered by following cycles: E_TR_CON, F_TR_CON
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Check thread geometry.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61234
Channel %1 block %2: ShopMill subroutine %4 cannot be executed, as not tested
by ShopMill
Parameters: %1 = Channel number
%2 = Block number, label
%4 = Subroutine name
Definitions: Before a ShopMill subroutine can be used, it has to be tested by ShopMill. Alarm trig-
gered by following cycle: E_HEAD.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: The subroutine has to be simulated first in ShopMill or loaded into the ShopMill operating
mode "Machine auto".
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61235
Channel %1 block %2: ShopTurn program %4 cannot be executed as not tested by
ShopTurn.
Parameters: %1 = Channel number
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-463