Siemens SINUMERIK 840D sl Series Diagnostics Manual page 260

Overview of Alarms
Remedy: Modify part program: Length 1 - 3 or 4 permissible for radius.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
16130
Channel %1 block %2 instruction not allowed with FTOCON
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: • Case 1: A plane change is not allowed if the modal G function FTOCON: "fine tool com-
pensation" is active.
• Case 2: Transformation selection is allowed only for zero transformation or transforma-
tion inclined axis, Transmit or Tracyl if FTOCON is active.
• Case 3: Tool change is not allowed with M06 if FTOCON has been active since the last
tool change.
• Case 4: Orientable tool holder is active.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Modify part program: Deselect fine tool compensation with FTOCOF.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
16140
Channel %1 block %2 FTOCON not allowed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The tool fine compensation (FTOC) is not compatible with the currently active transforma-
tion.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Modify part program: Deselect fine tool compensation with FTOCOF.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
16150
Channel %1 block %2 invalid spindle number with PUTFTOCF
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The spindle number programmed for PUTFTOC or PUTFTOCF is beyond the permitted
range for the spindle numbers.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Modify part program. Is the programmed spindle number available?
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
16200
Channel %1 block %2 spline and polynominal interpolation not available
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The spline and polynomial interpolation are options that are not contained in the basic
version of the control.
Reactions: - Correction block is reorganized.
2-260
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005