Siemens SINUMERIK 840D sl Series Diagnostics Manual page 943

08/2005
Program Con- Internal
tinuation:
400264
Pointer parameter machine control panel 1 incorrect
Definitions: A pointer is incorrect in the MCP1 parameter range.
Reactions: - Alarm display.
Remedy: Correct the PLC configuration in the FB1 parameters.
Program Con- Switch control OFF - ON.
tinuation:
400265
Pointer parameter machine control panel 2 incorrect
Definitions: A pointer is incorrect in the MCP 2 parameter range.
Reactions: - Alarm display.
Remedy: Correct the PLC configuration in the FB1 parameters.
Program Con- Switch control OFF - ON.
tinuation:
400266
Pointer parameter handheld unit incorrect
Definitions: A pointer is incorrect in the HHU parameter range.
Reactions: - Alarm display.
Remedy: Correct the PLC configuration in the FB1 parameters.
Program Con- Switch control OFF - ON.
tinuation:
400267
Access error
Definitions: MCP or HHU data could not be accessed
Reactions: - Alarm display.
Remedy: Check the MCP or HHU parameters of the FB1.
Program Con- Switch control OFF - ON.
tinuation:
400604
Set change with M06 in the machine data
Definitions: With the magazine type used (box magazine, chain), changing is possible only with M06.
If necessary, also check for impermissible settings at revolver magazines.
Reactions: - Alarm display.
Remedy: Set the value in the channel-specific machine data TOOL_CHANGE_MODE (MD 22550)
to 1.
Program Con- Internal
tinuation:
400902
Parameter ChanNo impermissible in FC 9
Definitions: The parameterized channel does not exist.
Reactions: - Alarm display.
Remedy: Correct the parameter.
Program Con- Switch control OFF - ON.
tinuation:
400903
Parameter IntNo impermissible in FC 9
Definitions: The parameterized interrupt does not exist.
Reactions: - Alarm display.
Remedy: Correct the parameter.
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-943