Siemens SINUMERIK 840D sl Series Diagnostics Manual page 179

08/2005
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: In a subroutine call the programmed number of passes P is zero or negative.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Program number of passes between 1 and 9 999.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14014
Channel %1 selected program %3 not available or will be edited
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Program name
Definitions: The selected parts program is not in the NCK memory or the access authorization for the
program selection is from a higher level than the current control status.
During creation, this program received the protection level of the NC control which was
active at the time.
In SW 5 or higher a program edited on HMI can no longer be started with NC Start.
The alarm will also be issued, if a file other than the specified definition file has been
selected for the GUD or macro definition.
Reactions: - Alarm display.
Remedy: Reload the program in the NCK memory or check and correct the name of the directory
(workpiece overview) and the program (program overview) and reselect.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
14015
Channel %1 block %2 program %3 is not enabled
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Program name
Definitions: The user has no execution authorization for the file, the file is not released.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Please inform the authorized personnel/service department. Change user authorization,
release file.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14016
Channel %1 block %2 error when calling the subroutine via M/T function
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The following conflict was detected in a subprogram call per M or T function:
In the block referenced by parameter %2:
• An M or T function replacement has already been activated
• A modal subprogram call is active
• A subprogram return jump is programmed
• An end of program is programmed
• An M98 subprogram call is active (only in external language mode)
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-179