Siemens SINUMERIK 840D sl Series Diagnostics Manual page 552

Overview of Alarms
101006
Password has been deleted !
Definitions: The password was deleted via the softkey "Delete password".
Remedy: Enter password.
101007
Password has not been set !
Definitions: To delete the password, a higher access authorization is required (at least user).
Remedy: Set the password with a higher access level.
101008
Actual access level: %1
Parameters: %1 = Access-level system, manufacturer, service or user.
Definitions: When selecting the alarm image, the current access level is displayed: system, manufac-
turer, service or user or keyswitch positions 3/2/1/0.
Remedy: --
101013
Input error - see Help key (i)
Definitions: PLC status A syntax error occurred while entering a value in the PLC status.
The input syntax is explained in a help image.
Remedy: --
101014
Error on reading PLC_data !
Definitions: --
Remedy: --
101015
Error on writing PLC_data !
Definitions: --
Remedy: --
101016
Error: Operand address greater than 65535 !!
Definitions: The value range of the operand address was exceeded.
Remedy: Use a smaller value range for the operand address.
101017
No PLC input forms found !
Definitions: There are no *.plc input screen forms in the target system.
Remedy: --
101018
Read-in possible only in active PLC status !
Definitions: The current PLC status mode is not active, e.g. if the softkey "Change" was pressed.
Remedy: Switch the PLC status to active.
101019
Not possible to initialize the HMI internal PLC status!
Definitions: --
Remedy: --
101020
Not possible to backup the HMI internal PLC status!
Definitions: --
Remedy: --
101100
No access rights !
Definitions: The access level set is too low to open the selected window.
Remedy: Enter a higher password.
2-552
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005