Siemens SINUMERIK 840D sl Series Diagnostics Manual page 479

08/2005
61304
Channel %1 Block %2: Allowance
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy:
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61305
Channel %1 Block %2: Dimension too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy:
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61306
Channel %1 Block %2: Permissible measuring difference exceeded
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm triggered by following cycles: CYCLE971, CYCLE972, CYCLE974, CYCLE977,
CYCLE978, CYCLE979, CYCLE982, CYCLE994.
Remedy: -Check setpoint value
-Increase parameter _TDIF
61307
Channel %1 Block %2: Incorrect measuring variant
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: The value of parameter _MVAR is impermissible.
61308
Channel %1 Block %2: Check measuring path FA
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: A traversing path for measuring was generated whose size was specified by parameter
_FA that describes the maximum distance before and after the switching position (work-
piece edge) and that must have a value greater than 0.
Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: Check parameter _FA.
61309
Channel %1 Block %2: Check probe type
Parameters: %1 = Channel number
%2 = Block number, label
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-479