Siemens SINUMERIK 840D sl Series Diagnostics Manual page 370

Overview of Alarms
response, the length of the acceleration path must be at least as large as the value in
parameter %4.
The alarm is of the technological type and is output whenever bit 2 in
$MN_ENABLE_ALARM_MASK is enabled. The MMC softkey 'Technology support' sets
and clears this bit in the MD.
Reactions: - Alarm display.
Remedy: Modify part program or reset MD $MN_ENABLE_ALARMMASK bit 2.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
22290
Channel %1 block %2 spindle operation for transformed spindle/axis %3 not possi-
ble (reason: error code %4).
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
%4 = Error code
Definitions: It is impermissible to start a spindle as long as it is used by a transformation. Reason:
spindle usage in a transformation requires axis operation which must not be exited.
This alarm may have the following reasons:
• Error code 1 : M3, M4 or M5 per synchronized action;
• Error code 2 : M41 through M45 per synchronized action;
• Error code 3 : SPOS, M19 per synchronized action;
• Error code 11 : DBB30 spindle stop;
• Error code 12 : DBB30 spindle start clockwise rotation;
• Error code 13 : DBB30 spindle start counterclockwise rotation;
• Error code 14 : DBB30 spindle positioning.
Reactions: - NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Resolve the conflict, for example by deactivating transformation prior to spindle start.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
22320
Channel %1 block %2 PUTFTOCF command could not be transferred
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The cyclic transfer of the PUTFTOCF data block (fine tool compensation) could not be
performed because the transfer area is already occupied.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Check the part program, in particular with regard to the other channels. Is a data block
being transferred by another channel?
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
22321
Channel %1 axis %2 PRESET not allowed during traverse motion
2-370
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005