Siemens SINUMERIK 840D sl Series Diagnostics Manual page 247

08/2005
%3 = String
Definitions: An error has occurred in interface generation mode. The (compiler) error message refers
to the program specified here. In particular when loading new cycle program on the NCK,
problems can occur if the value settings in machine data
$MN_MM_NUM_MAX_FUNC_NAMES and $MN_MM_NUM_MAX_FUNC_PARAM are
too small.
Reactions: - Alarm display.
Remedy: • Modify part program.
• If new cycle programs have been loaded on the NCK, you will normally need to increase
the values of $MN_MM_NUM_MAX_FUNC_NAMES and
$MN_MM_NUM_MAX_FUNC_PARAM. See also the explanations for alarm 6010.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
15180
Channel %1 block %2: Error on editing program %3 as INI/DEF file.
Parameters: %1 = Channel number
%2 = Block number, label
%3 = String
Definitions: Errors were found when processing an initialization program (INI file), or a GUD or macro
definition file (DEF file).
The error message which is then displayed refers to the program specified here.
Reactions: - Alarm display.
Remedy: Correct the initialization program (INI file), or the GUD or macro definition file (DEF file).
In connection with Alarm 12380 or 12460, also change the memory configuration.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
15185
Channel %1 %2 errors in INI file
Parameters: %1 = Channel number
%2 = Number of detected errors
Definitions: Errors were found when processing initialization program _N_INITIAL_INI. This alarm will
also be output, if errors are found during editing of _N_INITIAL_INI in the GUD definition
files or if errors are found on ramp-up in the macro definition files.
Reactions: - NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Please inform the authorized personnel/service department. Correct the INI or DEF file or
correct the MD and create a new INI file (via "Upload").
Program Con- Switch control OFF - ON.
tinuation:
15186
Channel %1 %2 errors in GUD, macro or INI file
Parameters: %1 = Channel number
%2 = Number of detected errors
Definitions: %2 errors were found when processing GUD/macro definition files (DEF files) or initializa-
tion files (INI files)
Alarm 15180 has already informed about the corresponding file.
Prior to that the errors shown were reported by error-specific alarms, e.g. 12080 "syntax
error".
Reactions: - NC Start disable in this channel.
- Interface signals are set.
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-247