Siemens SINUMERIK 840D sl Series Diagnostics Manual page 4

Preface
Hotline
If you have any questions, please contact our hotline:
A&D Technical Support
Phone: +49 (0) 180 5050 - 222
Fax: +49 (0) 180 5050 - 223
E-mail: mailto:adsupport@siemens.com
Internet: http://www.siemens.com/automation/support-request
If you have any queries (suggestions, corrections) in relation to this documenta-
tion, please fax or e-mail us:
Fax: +49 (0) 9131 98 - 63315
E-mail: mailto:motioncontrol.docu@siemens.com
Fax form: See the reply form at the end of the brochure.
Subject matter of this manual
This manual is intended as a work of reference. It allows the operator at the
machine tool:
− To correctly assess special situations when operating the machine.
− To ascertain the reaction of the system to the special situation.
− To utilize the possibilities for continued operation following the special sit-
uation.
− To follow references to other documentation containing further details.
Scope
This manual describes the alarms / messages from the NC kernel (NCK) area,
the PLC and the SIMODRIVE 611D drive and SINAMICS.
Other alarms can occur from the HMI/MMC (Human-Machine/Man-Machine
Communication) areas. These alarms are displayed on the operator panel in the
form of self-explanatory text. They are documented in the section on MMC mes-
sages.
For special situations in conjunction with the integrated PLC, please refer to the
SIMATIC S7-300 documentation.
The alarms are sorted by ascending alarm number in each section. There are
gaps in the sequence.
iv
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005