Siemens SINUMERIK 840D sl Series Diagnostics Manual page 269

08/2005
Reactions: - Alarm display.
Remedy: Set the "enable following axis overlay" VDI signal.
Program Con- Alarm display showing cause of alarm disappears. No further operator action necessary.
tinuation:
16772
Channel %1 block %2 axis %3 is the slave axis, the coupling is being opened
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis, spindle
Definitions: >The axis is active as a slave axis in a coupling. In the REF operation mode, the coupling
is opened. The alarm can be suppressed by means of machine data 11410
SUPPRESS_ALARM_MASK Bit29 = 1.
Reactions: - Alarm display.
Remedy: The coupling will be closed again after having exited the REF operation mode.
Program Con- Alarm display showing cause of alarm disappears. No further operator action necessary.
tinuation:
16773
Channel %1 axis %2 is the following axis. The axis/spindle disables of leading axes
%3 and %4 differ from one another.
Parameters: %1 = Channel number
%2 = Axis, spindle
%3 = Axis, spindle
%4 = Axis, spindle
Definitions: The axis is active in a coupling as a following axis. The master axes
have different states regarding axis/spindle disable.
The alarm can be suppressed with machine data 11415 SUPPRESS_ALARM_MASK_2
Bit0 =1.
Reactions: - Alarm display.
Remedy: Set the same axis/spindle disable for all master axes.
Program Con- Alarm display showing cause of alarm disappears. No further operator action necessary.
tinuation:
16774
Channel %1 Synchronization aborted for slave axis/spindle %2
Parameters: %1 = Channel number
%2 = Axis name, spindle number
Definitions: For the indicated axis, the synchronization procedure (EGONSYN or EGONSYNE) was
aborted.
There are several reasons for aborting the synchronization process:
- RESET
- End of program
- Axis goes to follow-up mode
- Rapid stop caused by an alarm
Reactions: - NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
- Channel not ready.
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-269