Siemens SINUMERIK 840D sl Series Diagnostics Manual page 575

08/2005
105018
Error on generating program ! %1
Parameters: %1 = --
Definitions: The program could not be created; there may no longer be sufficient memory.
Remedy: --
105019
Error on opening window ! %1
Parameters: %1 = --
Definitions: The window could not be opened.
System error that should not occur in normal operation.
Remedy: --
105020
Error on closing window ! %1
Parameters: %1 = --
Definitions: The window could not be closed.
System error that should not occur in normal operation.
Remedy: --
105021
Error on generating workpiece ! %1
Parameters: %1 = --
Definitions: The workpiece could not be created.
Remedy: --
105022
Error on enable ! %1
Parameters: %1 = --
Definitions: The program could not be enabled.
Remedy: --
105023
File %1 exists already !
Parameters: %1 = --
Definitions: The file cannot be copied to this directory, as a file with the same name is already here.
Remedy: --
105024
Check values! - At least 1 value not within input limits!
Definitions: An invalild value was entered in the cycle parameter image.
Remedy: --
105025
Please wait, structuring directory !
Definitions: The data required for the display of the directory is being determined.
Remedy: --
105026
Caution! Simulated program not identical to edited program!
Definitions: The program being executed is not identical to the program opened in the editor.
Remedy: --
105027
Selection is being made
Definitions: --
Remedy: --
105028
Selection is impossible
Definitions: --
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-575