Siemens SINUMERIK 840D sl Series Diagnostics Manual page 222

Overview of Alarms
The error cause is explained further by an error code.
If the error code is an integer, the lower-value three decimal places specify the number of
the edge, in which the error was detected, while the thousandth digit explains the reason
in more detail.
-1: The tool was deleted.
-2: The number of contour elements (edges) explaining the tool, has changed.
1000: The edge center has changed
2000: The edge radius has changed.
3000: The initial angle has changed.
4000: The final angle has changed.
Reactions: - Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Remedy: Change NC program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14551
Channel %1 block %2 contour tool: angle area of edge D%3 larger than 359 degrees
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Edge number, label
Definitions: A single edge must cover a max. angle area of 359 degrees.
Reactions: - Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Remedy: Check tool definition.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14600
Channel %1 block %2 reload buffer %3 cannot be established
Parameters: %1 = Channel number
%2 = Block number, label
%3 = File name
Definitions: The download buffer for "execute from external" could not be created. Possible causes:
• Not enough memory available (for minimum see MD
$MN_MM_EXT_PROG_BUFFER_SIZE)
• No resources available for MMC NCK communication (see MD
$MN_MM_EXT_PROG_NUM)
• The file already exists
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: • Release memory, e.g. by deleting part programs
• Modify MD $MN_MM_EXT_PROG_BUFFER_SIZE and/or
$MN_MM_EXT_PROG_NUM.
2-222
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005