Siemens SINUMERIK 840D sl Series Diagnostics Manual page 303

08/2005
n ... Associated tool number T
m ... Tool edge number D
x ... Parameter number P
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
17191
Channel %1 block %2 T= %3 not existing, program %4
Parameters: %1 = Channel number
%2 = Block number, label
%3 = T number or T identifier
%4 = Program name
Definitions: A tool identifier which the NCK does not recognize was programmed.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: If the program pointer is at an NC block which contains the specified T identifier: If the
program is incorrect, remedy the error with a correction block and continue the program. If
the data block is missing, create one. You can do this by downloading a data block with all
the defined D numbers onto the NCK (via MMC with overstore) and continue the program.
If the program pointer is at an NC block which does not contain the specified T identifier:
The error occurred at an earlier point in the program where the T command appeared, but
the alarm was not output until the change command was detected.
If the program is incorrect - T5 programmed instead of T55 - the current block can be cor-
rected with a correction block; i.e. if only M06 is entered, you can correct the block with
T55 M06. The incorrect T5 line remains in the program until it is terminated by a RESET
or end of program.
In complex program structures with indirect programming, it may not be possible to cor-
rect the program. In this case, you can only intervene locally with an overstore block - with
T55 in the example. If the data block is missing, create one. You can do this by download-
ing the data block of the tool with all the defined D numbers onto the NCK (via MMC with
overstore), program the T command with overstore, and continue the program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
17192
TO unit %1 invalid tool designation of '%2', duplo no. %3. No more replacement
tools possible in '%4'.
Parameters: %1 = TO unit
%2 = Tool identifier
%3 = Duplonummer
%4 = Group identifier
Definitions: The tool with the specified tool identifier, duplo number cannot accept the group identifier.
Reason: The maximum number of replacement tools allowed has already been defined.
The name allocation causes the tool to be reallocated to a tool group which already con-
tains the maximum number of replacement tools allowed on this machine.
Reactions: - Interface signals are set.
- Alarm display.
Remedy: Use fewer replacement tools or request a different maximum setting from the machine
manufacturer.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
17193
Channel %1 block %2 the active tool is no longer on toolholder no./spindle no. %3,
program %4
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-303