Siemens SINUMERIK 840D sl Series Diagnostics Manual page 125

08/2005
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
10792
Channel %1 block %2 illegal interpolation type during linear programming with
angles
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Only spline or linear interpolation is permitted for programming two straight lines with
angle specification. Circular or polynomial interpolation is not allowed.
Reactions: - Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
10793
Channel %1 block %2 second block missing during linear programming with
angles
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The second block is missing during programming of two straight lines with angle specifi-
cation. This situation only occurs if the first subblock is also the last block of a program, or
if the first subblock is followed by a block with a preprocessor stop.
Reactions: - Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
10794
Channel %1 block %2 angle specification missing in second block during linear
interpolation with angles
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The angle is missing from the second block during programming of two straight lines with
angle specification. This error can only occur if an angle was programmed in the preced-
ing block, but no axis of the active plane was programmed in that block. The cause of the
error may therefore also have been the intention to program a single straight line with an
angle in the previous block. In this case, exactly one axis of the active plane must be pro-
grammed.
Reactions: - Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-125