Siemens SINUMERIK 840D sl Series Diagnostics Manual page 174

Overview of Alarms
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
12701
Channel %1 block %2 illegal interpolation type for contour definition active
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: In one contour definition block, G01 is not active as interpolation function. In one contour
definition block, the linear interpolation always has to be selected with G01. G00, G02,
G03, G33 etc. are not permitted.
Reactions: - Correction block
- Interface signals are set.
- Alarm display.
Remedy: Modify part program. Program linear interpolation G01.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
12710
Channel %1 block %2 illegal language element in external language mode
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The programmed language element is not allowed or unknown in external language
mode. Only the language elements from Siemens mode which are used for subprogram
calls (except for Lxx) and the language constructs for program repetition with REPEAT
(UNTIL) are allowed.
Reactions: - Correction block
- Interface signals are set.
- Alarm display.
Remedy: Modify part program.
Check that the language command is available in Siemens mode. Switch to Siemens
mode with G290. Program the command in the next block and switch back to the external
language mode in the following block.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
12720
Channel %1 block %2 program number for macro call (G65/G66) missing
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: During macro call with G65/G66 no program number was defined. The program number
must be programmed with address "P".
Reactions: - Correction block
- Interface signals are set.
- Alarm display.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
12722
Channel %1 block %2 multiple ISO_2/3 macro or cycle calls in the block
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: A mixture of cycle and macro calls are programmed in a block, e.g. cycle calls with G81 -
G89 together with an M macro in the block or a G65/G66 macro call together with M mac-
ros in the block.
2-174
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005