Siemens SINUMERIK 840D sl Series Diagnostics Manual page 144

Overview of Alarms
- Interface signals are set.
- Alarm display.
Remedy: Press the NC Stop key and select the function "Correction block" with the softkey PRO-
GRAM CORRECT. The correction pointer positions on the incorrect block.
Analyze the block and correct it in accordance with the syntax rules given in the Program-
ming Guide.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
12090
Channel %1 block %2 unexpected parameter %3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Disallowed parameters in the text
Definitions: The programmed function has been predefined; no parameters are allowed in its call. The
first unexpected parameter is displayed.
Example: On calling the predefined subroutine TRAFOF (switching off a transformation)
parameters have been transferred (one or more).
Reactions: - Correction block
- Interface signals are set.
- Alarm display.
Remedy: Press the NC Stop key and select the function "Correction block" with the softkey PRO-
GRAM CORRECT. The correction pointer positions on the incorrect block.
Program function without parameter transfer.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
12100
Channel %1 block %2 number of passes %3 not permissible
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Number of passes
Definitions: The subroutines called with MCALL are modal, i.e. after each block with positional infor-
mation a routine run is automatically performed once. For this reason, programming of the
number of passes under address P is not allowed.
The modal call is effective until another MCALL is programmed, either with a new subrou-
tine name or without (delete function).
Reactions: - Correction block
- Interface signals are set.
- Alarm display.
Remedy: Press the NC Stop key and select the function "Correction block" with the softkey PRO-
GRAM CORRECT. The correction pointer positions on the incorrect block.
Program the subroutine call MCALL without number of passes.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
12110
Channel %1 block %2 block syntax cannot be interpreted
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The addresses programmed in the block are not permissible together with the valid syn-
tax defining G function, e.g. G1 I10 X20 Y30 F1000.
An interpolation parameter must not be programmed in the linear block.
Reactions: - Correction block
2-144
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005