Siemens SINUMERIK 840D sl Series Diagnostics Manual page 444

Overview of Alarms
Reactions: - Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Remedy: Either reduce finishing allowance or increase depth infeed.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61111
Channel %1 Block %2: Infeed width > Tool diameter
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The programmed infeed width is greater than the diameter of the active tool. Alarm trig-
gered by following cycles: CYCLE71, POCKET3, POCKET4.
Reactions: - Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Remedy: Infeed width must be reduced.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61112
Channel %1 Block %2: Tool radius negative
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The radius of the active tool is negative. This is illegal. Alarm triggered by following
cycles: CYCLE72, CYCLE76, CYCLE77, CYCLE90.
Remedy: Change the tool radius.
61113
Channel %1 Block %2: Parameter _CRAD too large for corner radius
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The parameter for the corner radius _CRAD has been specified too large. Alarm triggered
by following cycle: POCKET3.
Reactions: - Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Remedy: Parameter must be reduced.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61114
Channel %1 Block %2: Machining direction G41/G42 incorrectly defined
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The machining direction of the cutter radius compensation G41/G42 has been incorrectly
selected. Alarm triggered by following cycle: CYCLE72.
Reactions: - Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Remedy: Change machining direction.
2-444
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005