Siemens SINUMERIK 840D sl Series Diagnostics Manual page 201

08/2005
Definitions: Position information was programmed for an axis position but no transformation was
active.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Modify the program.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
14144
Channel %1 block %2 PTP movement not allowed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The PTP G code was programmed for a movement other than G0 or G1.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Modify the program.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
14146
Channel %1 block %2 CP or PTP movement without transformation not allowed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The CP or PTP G code was programmed for a movement but no transformation was
active.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Modify the program.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
14147
Channel %1 block %2 spline for orientation not possible.
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: If an orientation has been programmed while BSPLINE is active, the interpolation of
tool orientation must be interpolated via a 2nd space curve. This means that G code ORI-
CURVE
must be active for the interpolation of the orientation.
Reactions: - Correction block is reorganized.
- Interpreter stop
- Interface signals are set.
- Alarm display.
Remedy: Change the NC program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14148
Channel %1 illegal reference system for Cartesian manual traverse
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-201