Siemens SINUMERIK 840D sl Series Diagnostics Manual page 16

Overview of Alarms
Definitions: With this alarm, internal alarm states are displayed that, in conjunction with the trans-
ferred error number, provide information on the cause and location of the error.
Reactions: - Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Make a note of the error text and contact Siemens AG A&D MC, Hotline (tel./fax: see
alarm 1000)
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
1014
Channel %1 system error %2
Parameters: %1 = Channel number
%2 = System error number
Definitions: With this alarm, internal alarm states are displayed that, in conjunction with the trans-
ferred error number, provide information on the cause and location of the error.
Reactions: - Mode group not ready.
- Local alarm reaction.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Make a note of the error text and contact Siemens AG A&D MC, Hotline (tel./fax: see
alarm 1000)
Program Con- Clear alarm with the RESET key in all channels of this mode group. Restart part program.
tinuation:
1015
Channel %1 axis %2 system error %3
Parameters: %1 = Channel number
%2 = Axis number
%3 = System error number
Definitions: With this alarm, internal alarm states are displayed that, in conjunction with the trans-
ferred error number, provide information on the cause and location of the error. Especially
with parameter %3 (system error number) = 840001 = Problem with tool management,
the identification for the axis is not contained in parameter %2, but instead, further infor-
mation for the diagnostics (= Status of the data management/magazine no./location no./T
no.)
Reactions: - Local alarm reaction.
- Channel not ready.
- Interface signals are set.
- Alarm display.
Remedy: Make a note of the error text and contact Siemens AG A&D MC, Hotline (tel./fax: see
alarm 1000)
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
1016
Channel %1 axis %2 system error %3
Parameters: %1 = Channel number
%2 = Axis number
2-16
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005