Siemens SINUMERIK 840D sl Series Diagnostics Manual page 92

Overview of Alarms
10226
[up to SW 3.x only] Channel %1: reset aborted
Parameters: %1 = Channel number
Definitions: An error occurred during the reset, with the result that the sequence could not be contin-
ued.
Reactions: - Mode group not ready.
- Channel not ready.
- NC Start disable in this channel.
- Alarm display.
Remedy: Press RESET again.
Program Con- Clear alarm with the RESET key in all channels of this mode group. Restart part program.
tinuation:
10227
[up to SW 3.x only] Channel %1: command aborted
Parameters: %1 = Channel number
Definitions: An error occurred while a command was active, with the result that the sequence could
not be continued.
Reactions: - Alarm display.
Remedy: Activate the command again.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
10230
[up to SW 3.x only] Mode group %2 channel %1 program interruption does not per-
mit mode change
Parameters: %1 = Channel number
%2 = Mode group number
Definitions: While in the "program interrupted" status (interface signal DB 21 - 28, DBX 35.3) - trig-
gered by an NC Stop followed by a mode change to JOG - it is only possible to change
back to the previous mode (AUTOMATIC or MDA).
Reactions: - Alarm display.
Remedy: You can change the mode via the "program aborted" status (interface signal DB 21 - 28,
DBX 35.4) - triggered by a "reset".
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
10231
[up to SW 3.x only] Mode group %2 channel %1 program stop does not permit
mode change
Parameters: %1 = Channel number
%2 = Mode group number
Definitions: While in the "program stopped" status (interface signal DB 21 - 28, DBX 35.2, triggered by
an NC Stop), it is only possible to change back to continuous program operation (by
means of an NC Start).
Reactions: - Alarm display.
Remedy: You can change the mode via the "program aborted" status (interface signal DB 21 - 28,
DBX 35.4) - triggered by a "reset".
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
10232
[up to SW 3.x only] Mode group %2 channel %1 does not permit mode change
Parameters: %1 = Channel number
%2 = Mode group number
Definitions: The change to the desired mode is not permitted. You can only perform the mode change
in the "reset" state.
2-92
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005