Siemens SINUMERIK 840D sl Series Diagnostics Manual page 481

08/2005
61316
Channel %1 Block %2: Center and radius cannot be determined
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: No circle can be calculated from the measured points, as all measured points lie on a
straight line.
Remedy: Program change
61317
Channel %1 Block %2: Check parameter CYCLE116
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Parameterization faulty; requires 3 or 4 points to calculate the center point. Alarm is trig-
gered: CYCLE979.
Remedy: Change parameterization of CYCLE116.
61318
Channel %1 Block %2: Check weighting factor _K
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Parameter _K is 0. Alarm is triggered: CYCLE974, CYCLE977, CYCLE978, CYCLE979,
CYCLE994, CYCLE998.
Remedy: Check parameter _K.
61319
Channel %1 Block %2: Check call parameter CYCLE114
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Internal error in measuring cycles. Alarm is triggered: CYCLE974, CYCLE977,
CYCLE978, CYCLE979, CYCLE994, CYCLE998.
Remedy: Check call parameter CYCLE114.
61320
Channel %1 Block %2: Check tool number
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: With active tool management, parameter _TNUM=0 and parameter _TNAME is not set or
the specified tool name of tool management is unknown.
The alarm can be triggered by the following measuring cycles: all measuring cycles.
Remedy: Check parameter _TNUM, _TNAME.
61321
Channel %1 Block %2: Check WO memory number
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: WO with the number specified in _KNUM not existing. Alarm is triggered: CYCLE974,
CYCLE977, CYCLE978, CYCLE979, CYCLE994, CYCLE998.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Check parameter _KNUM.
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-481