Siemens SINUMERIK 840D sl Series Diagnostics Manual page 301

08/2005
• Tool parameters (tool type, length,...) defined? The dimensions of the tool edge must
have been entered previously either through the operator panel or through a tool data file
in NCK.
Description of the system variables $TC_DPx[t, d] as included in a tool data file.
x ... Correction parameter number P
t ... Associated tool number T
d ... Tool correction number D
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
17181
Channel %1 block %2 T no.= %3, D no.= %4 not existing
Parameters: %1 = Channel number
%2 = Block number, label
%3 = T number
%4 = D number
Definitions: A programmed D number was not recognized by the NC. By default, the D number refers
to the specified T number. If the flat D number function is active, T= 1 is output.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: If the program is incorrect, remedy the error with a correction block and continue the pro-
gram. If the data block is missing, download a data block for the specified T/D values onto
the NCK (via MMC with overstore) and continue the program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
17182
Channel %1 block %2 illegal sum correction number
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: An attempt was made to access a non-defined total offset of the current tool edge.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Access the total offset memory with $TC_SCP*, $TC_ECP*, check the total offset selec-
tion DLx or tool selection Ty or offset selection Dz.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
17183
Channel %1 block %2 H number already available in T no.= %3, D no.= %4
Parameters: %1 = Channel number
%2 = Block number, label
%3 = T number
%4 = D number
Definitions: Each H number (except for H=0) must be assigned in a TO unit only once.
The indicated edge already has the H number.
If the H number shall be assigned more than once, machine date 10890, bit 3 must be set
= 1.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: • Change program:
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-301