Siemens SINUMERIK 840D sl Series Diagnostics Manual page 219

08/2005
- Alarm display.
- NC Stop on alarm at block end.
Remedy: Change tool definition
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14542
Channel %1 block %2 contour tool: the min. limit angle has not been programmed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: On defining a contour tool, either no limit angle must be indicated, or both the minimum
and the maximum limit angle must be programmed once for each.
Reactions: - Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Remedy: Change tool definition
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14543
Channel %1 block %2 contour tool: the max. limit angle has not been programmed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: On defining a contour tool, either no limit angle must be indicated, or both the minimum
and the maximum limit angle must be programmed once for each.
Reactions: - Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Remedy: Change tool definition
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14544
Channel %1 block %2 contour tool: edge D%3 is not positioned between the two
border edges
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Edge number, label
Definitions: On defining a form tool with limit, all edges must be positioned between the edge with the
minimum limit angle and the edge with the maximum limit angle when rotating counter-
clockwise.
Reactions: - Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Remedy: Change tool definition
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-219