Siemens SINUMERIK 840D sl Series Diagnostics Manual page 240

Overview of Alarms
14830
Channel %1 block %2 wrong feed type selected
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: G97 has been programmed in the displayed block although G96 was not (or G97 already)
active previously.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Remove G97 from the displayed block and program the correct feed type (G93, G94, G95
or G96) for the machining section which follows.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14840
Channel %1 block %2 incorrect value range for constant cutting speed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The programmed cutting speed is not within the input range
Input range metric: 0.01 to 9 999.99 [m/min]
Input range inch: 0.1 to 99 999.99 [inch/min].
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Program cutting speed under address S within the permissible range of values.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14900
Channel %1 block %2 center point and end point programmed simultaneously
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: When programming a circle by means of the opening angle, the circle center point was
programmed together with the circle end point. This is too much information for the circle.
Only one of the two points is allowed.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Select the programming variant guaranteeing that the dimensions are definitely taken
over from the workpiece drawing (avoidance of calculation errors).
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14910
Channel %1 block %2 invalid angle of aperture for programmed circle
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: When programming a circle by means of the opening angle, a negative opening angle or
an opening angle greater than or equal to 360 degrees has been programmed.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Program opening angle within the allowed range of values between 0.0001 and 359.9999
[degrees].
2-240
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005