Siemens SINUMERIK 840D sl Series Diagnostics Manual page 206

Overview of Alarms
Parameters: %1 = Channel number
%2 = Block number, label
%3 = H number of ISO mode
Definitions: The specified H number is not assigned to a tool (ISO_2).
Reactions: - Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14185
Channel %1 block %2 D number %3 is not defined
Parameters: %1 = Channel number
%2 = Block number, label
%3 = D number of ISO mode
Definitions: The specified D number is not assigned to a tool (language mode ISO_2).
Reactions: - Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14190
Channel %1 block %2 H number with G49
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: G49 (select tool length compensation) and an H word not equal to H0 have been pro-
grammed simultaneously.
Reactions: - Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14195
Channel %1 block %2 D number with G49
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: G49 (select tool length compensation) and an D word not equal to D0 have been pro-
grammed simultaneously.
Reactions: - Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
2-206
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005