Siemens SINUMERIK 840D sl Series Diagnostics Manual page 258

Overview of Alarms
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
16100
Channel %1 block %2 spindle %3 not available in the channel
Parameters: %1 = Channel number
%2 = Block number, label
%3 = String
Definitions: Mistake in programming: This channel does not recognize the spindle number. The alarm
can occur together with a dwell or SPI function.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Please inform the authorized personnel/service department. Check the part program to
determine whether the programmed spindle number is correct and whether the program
is run in the correct channel.
Check MD 35000 SPIND_ASSIGN_TO MACHAX for all machine axes to see whether
one of them contains the programmed spindle number. This machine axis number must
be entered in a channel axis of the channel-specific machine data 20070
AXCONF_MACHAX_USED.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
16105
Channel %1 block %2 spindle %3 cannot be assigned
Parameters: %1 = Channel number
%2 = Block number, label
%3 = String
Definitions: Mistake in programming: The programmed spindle is not assigned a real axis by the spin-
dle number converter. The alarm can be issued after improper use of
$SC_SPIND_ASSIGN_TAB[].
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Correct setting data or modify part program.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
16110
Channel %1 block %2 spindle %3 for dwell time not in control mode
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis, spindle
Definitions: The spindle can be in the positioning mode, oscillating mode and control mode. With the
M command M70 it can be changed from a spindle to an axis. The control mode is divided
into the speed-controlled and position-controlled mode, and it is possible to alternate
between these with the keywords SPCON and SPCOF.
Positioning mode:
Position control (spindle position under SPOS/SPOSA)
Oscillating mode:
Speed control (M41 - M45 or M40 and S...)
Control mode:
Speed control (spindle speed under S..., M3/M4/M5)
2-258
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005