Siemens SINUMERIK 840D sl Series Diagnostics Manual page 136

Overview of Alarms
%2 = Block number, label
%3 = Number of curve table
Definitions: The conditions for converting a programmed contour to a curve table were not fulfilled in
this block.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Correct the part program and start it again.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
10944
Channel %1 block %2 curve table %3: illegal transformation
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Number of curve table
Definitions: It is impermissible to use a transformation in a curve table if the leading axis or following
axis programmed in CTABDEF is involved in the transformation. Exception: TRAANG.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Correct NC part program.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
10945
Channel %1 block %2 curve table %3: illegal coupling of axes
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Number of curve table
Definitions: It is not possible to program axis links for the leading axes and following axis programmed
in CTABDEF.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Correct NC part program.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
10946
Channel %1 block %2 curve table %3: no contour defined
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Number of curve table
Definitions: No movement for the leading axis was programmed between CTABDEF and CTABEND.
A curve table is not permitted without a contour.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
2-136
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005