Siemens SINUMERIK 840D sl Series Diagnostics Manual page 453

08/2005
61183
Channel %1 block %2: Clearance mode _FR outside of value range 0..2.
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The retraction mode value lies outside of the valid range. Alarm triggered by following
cycles: CYCLE800.
Remedy: Check installation and start-up of swivel cycle CYCLE800 -> retraction
parameter _FR.
61184
Channel %1 block %2: No solution possible with current input angle values
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The surface defined via the input angle cannot be processed with the machine. Alarm trig-
gered by following cycles: CYCLE800.
Remedy: Check the angle entered for the swivelling of the machining plane.
61185
Channel %1 block %2: no or wrong (min > max) angle areas of rotary axes agreed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The rotary axis angle range is invalild. Alarm triggered by following cycles: CYCLE800.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Check installation and start-up of the swivel cycle CYCLE800.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61186
Channel %1 block %2: Invalid rotary axis vectors --> Start-up check swivel cycle
CYCLE800
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: No or incorrect entry for rotary axis vector V1 or V2. Alarm triggered by following cycles:
CYCLE800.
Remedy: Check installation and start-up of the swivel cycle CYCLE800.
61187
Channel %1 block %2: block search mode not allowed -> select block search with
contour calculation
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The alarm is triggerd by the following cycles: CYCLE800.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Select block search with contour calculation.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-453