Siemens SINUMERIK 840D sl Series Diagnostics Manual page 458

Overview of Alarms
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Delete and reprogram the positioning block.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61210
Channel %1 block %2: Block search element not found
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The element specified for the block search does not exisit.
Alarm triggered by following cycles: E_MANAGE, E_PS_CIR, E_PS_MRX, E_PS_POL,
E_PS_SEQ, E_PS_XYA, F_MANAGE, F_PS_CIR, F_PS_MRX, F_PS_SEQ
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Repeat block search.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61211
Channel %1 block %2: Absolute reference missing
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: An incremental indication was made, but the absolute reference is unknown.
Alarm triggered by following cycles: E_MI_CON, E_MI_PL, E_PI_CIR, E_PI_REC,
E_PO_CIR, E_PO_REC, E_PS_CIR, E_PS_HIN, E_PS_MRX, E_PS_POL, E_PS_SEQ,
E_PS_XYA, E_SL_CIR, E_SL_LON, F_PS_CIR, F_PS_MRX, F_PS_SEQ
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Program an absolute position prior to using incremental indications.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61212
Channel %1 block %2: Wrong tool type
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The tool type is not suitable for machining.
Alarm triggered by following cycles: CYCLE92, CYCLE951, E_DR, E_DR_O1,
E_DR_PEC, E_DR_SIN, E_MI_TXT, F_DR, F_DR_PEC, F_DR_SIN, F_DRILL,
F_DRILLC, F_DRILLD, F_DRM_DR, F_DRM_PE, F_DRM_SI, F_GROOV, F_MI_TXT,
F_MT_LEN, F_PARTOF, F_ROU_Z, F_ROUGH, F_SP_EF, F_TAP, F_TR_CON,
F_UCUT_T
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
2-458
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005