Siemens SINUMERIK 840D sl Series Diagnostics Manual page 188

Overview of Alarms
the D number changes, the new parameter set is active (D0 is used for deselecting the
correction values).
N10 G.. X... Y... T15 ; Parameter set D1 of T15 active
N50 G.. X... D3 M..
N60 G.. X.. T20
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Program D numbers in the permissible value range (D0, D1 to D9).
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14091
Channel %1 block %2 illegal function, index %3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Index
Definitions: A function was programmed or triggered which is not allowed in the current program con-
text. The code of the function in question is entered in the "index" parameter:
Index == 1: "RET" command was programmed in the main program level
Index == 2: Conflict between "cancel level"/"clear number of passes" and "implicit GET"
Index == 3: Conflict between ASUB and start immediately after selection of overstore (up
to P3)
Index == 4: MD MN_G53_TOOLCORR = 1 : SUPA/G153/G53 programmed in G75
Index == 5: POSRANGE command not programmed in synchronized action
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Index == 1: Substitute "RET" command with M17/M30
Index == 2: Insert an auxiliary block (e.g. M99) after the subroutine call to which the "can-
cel level"/"clear number of passes" refers
Index == 3: Overstore an auxiliary block (e.g. M99), then start ASUP (up to P3)
Index == 4: With MD MN_G53_TOOLCORR = 1: Do not activate SUPA/G53/G153 in the
G75 block
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
14092
Channel %1 block %2 axis %3 is wrong axis type
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Definitions: One of the following three programming errors has occurred:
1. The keyword WAITP(x) "Wait with block change until the specified positioning axis has
reached its end point" has been used for an axis that is not a positioning axis.
2. G74 "Reference point approach from the program" has been programmed for a spindle.
(Only axis addresses are permitted).
3. The keyword POS/POSA has been used for a spindle. (The keywords SPOS and
SPOSA must be programmed for the spindle positions).
Reactions: - Correction block is reorganized.
- Interface signals are set.
2-188
; Parameter set D3 of T15 active
; Parameter set D1 of T20 active
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005