Siemens SINUMERIK 840D sl Series Diagnostics Manual page 467

08/2005
61246
Channel %1 block %2: Safety distance too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The safety clearance is too small for machining.
Alarm triggered by following cycle: CYCLE79.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Increase safety clearance.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61247
Channel %1 block %2: Blank radius too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The blank radius is too small for machining.
Alarm triggered by following cycle: CYCLE79.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Increase blank radius.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61248
Channel %1 block %2: Infeed too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The infeed is too small for machining.
Alarm triggered by following cycle: CYCLE79.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Increase infeed.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61249
Channel %1 block %2: Number of edges too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The number of edges is too small.
Alarm triggered by following cycle: CYCLE79.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Increase number of edges.
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-467