Siemens SINUMERIK 840D sl Series Diagnostics Manual page 250

Overview of Alarms
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Syntax error! A label must have at least 2 but no more than 32 characters, and the first
two characters must be alphabetic or underscore characters. Labels must be concluded
with a colon.
Reactions: - Alarm display.
Remedy: Repeat the input with corrected label.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
15350
Channel %1 block %2 search target not found
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The specified program has been searched to the end of the program without the selected
search target having been found.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Check the part program, change the block search (typing error in the part program) and
restart the search.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
15360
Channel %1 illegal target of block search (syntax error)
Parameters: %1 = Channel number
Definitions: The specified search target (block number, label or string) is not allowed in block search.
Reactions: - Alarm display.
Remedy: Correct target of block search.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
15370
Channel %1 target of block search not found
Parameters: %1 = Channel number
Definitions: In a block search, an impermissible search target has been specified (e.g. negative block
number).
Reactions: - Alarm display.
Remedy: Check the specified block number, label or character string. Repeat entry with correct
search target.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
15380
Channel %1 block %2 illegal incremental programming in axis %3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis
Definitions: The first axis programming after "search to block end point" is performed incrementally.
This is not allowed in the following situations:
• After searching the target a transformation change has taken place.
• A frame with rotation component is active. The programmed axis is involved in the rota-
tion.
2-250
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005