Siemens SINUMERIK 840D sl Series Diagnostics Manual page 317

08/2005
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: • Modify the protection zone definition or do not simultaneously activate protection zones
that have different orientations.
• Check machine data and modify the protection zone definition if necessary.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
18005
Channel %1 block %2 serious error in definition of NCK-specific protection zone
%3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Protection zone number
Definitions: The protection zone definition must be terminated with EXECUTE before a preprocessing
stop is performed. This also applies to any that are initiated implicitly such as with G74,
M30, M17.
Reactions: - Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
18006
Channel %1 block %2 serious error in definition of channel-specific protection
zone %3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Protection zone number
Definitions: The protection zone definition must be terminated with EXECUTE before a preprocessing
stop is performed. This also applies to any that are initiated implicitly such as with G74,
M30, M17.
Reactions: - Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
18100
Channel %1 block %2 invalid value assigned to FXS[]
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The following values are valid at the present time:
0: "Deselect traverse against fixed stop"
"Select traverse against fixed stop" valid.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: --
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-317