Siemens SINUMERIK 840D sl Series Diagnostics Manual page 91

08/2005
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
10221
[up to SW 3.x only] Channel %1 not stopped at end of block
Parameters: %1 = Channel number
Definitions: The reorganization of NC blocks starting at the current block (REORG) is only possible at
the end of the block.
Reactions: - Alarm display.
Remedy: Stop the channel (NC Stop) and repeat the action.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
10222
Channel %1 inter-channel communication not possible
Parameters: %1 = Channel number
Definitions: This channel has received a negative acknowledgment from the inter-channel communi-
cation because the destination channel number is not known, e.g.: START(x) or
WAITE(x) but channel x has not been initialized
Reactions: - Alarm display.
Remedy: This is an indication of possible discrepancies. The program continues if no acknowledg-
ment is called for.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
10223
Channel %1: Command %2 is already occupied
Parameters: %1 = Channel number
%2 = Event name
Definitions: This channel has received a negative acknowledgment from the inter-channel communi-
cation because this command is already active or has not yet been terminated, e.g.:
INIT(x,"ncprog") but a program select request is already active for channel x.
Reactions: - Alarm display.
Remedy: This is an indication of possible discrepancies. The program continues if no acknowledg-
ment is called for.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
10224
[up to SW 3.x only] Channel %1: command denied
Parameters: %1 = Channel number
Definitions: The channel has received a command that cannot be executed, e.g.: activation of a pro-
gram test in automatic mode is only possible in the reset state.
Reactions: - Alarm display.
Remedy: Press RESET and activate the command again.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
10225
Channel %1: command denied
Parameters: %1 = Channel number
Definitions: The channel has received a command. The command cannot be executed.
Reactions: - Alarm display.
Remedy: Press RESET.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-91